How To Clone Hard Drive From Linux

Cloning a hard drive from Linux is a great way to back up your data or transfer it to a new computer. Cloning a hard drive copies all the data and settings from one hard drive to another, so you don’t have to reinstall programs or reconfigure settings. The process can be a bit tricky, so this guide will walk you through the steps of cloning a hard drive from Linux.

Step 1: Install Clonezilla

Clonezilla is a free open-source disk cloning software that can be used to clone hard drives from Linux. To install Clonezilla, open a terminal and run the following command:

$ sudo apt-get install clonezilla

Once the installation is complete, you can launch Clonezilla by typing the following command:

$ sudo clonezilla

Step 2: Choose a Cloning Method

Clonezilla provides a few different cloning methods. The simplest method is to clone the entire hard drive. This will create an exact copy of the hard drive, including all the data and settings. If you only want to clone a single partition, you can choose the “Partclone” option.

For this guide, we will be cloning the entire hard drive. To do this, select the “Local_Dev to Local_Dev” option.

Step 3: Select the Source and Destination Drives

In this step, you will need to select the source and destination drives. The source drive is the drive that you want to clone, and the destination drive is the drive that you want to clone it to. Select the drives from the list and click “Next.”

Step 4: Start the Cloning Process

Once you have selected the source and destination drives, you can start the cloning process. Clonezilla will now start copying all the data and settings from the source drive to the destination drive. The process may take some time depending on the size of the drives.

Step 5: Verify the Cloning Process

Once the cloning process is complete, it’s a good idea to verify that all the data has been copied correctly. To do this, you can use the “Verify” option in Clonezilla. This will compare the source and destination drives and report any discrepancies.

Step 6: Disconnect the Drives

Once you have verified that all the data has been copied correctly, it’s time to disconnect the drives. Unplug the source drive from the computer, then plug in the destination drive. You can now boot into the destination drive and you should see all the data and settings from the source drive.

Conclusion

Cloning a hard drive from Linux is a great way to back up your data or transfer it to a new computer. The process can be a bit tricky, but with the help of Clonezilla, you can easily clone your hard drive in just a few simple steps. Once the cloning process is complete, you can boot into the destination drive and you should see all the data and settings from the source drive.